TileHolder™

The exposed TileHolder adhesive maintains full tackiness for up to 24 hours in clean, dry conditions. Minimize exposure to dust and debris during this window. For optimal bond strength, install tiles as soon as possible after removing the release liner.

Install tiles immediately after removing the protective liner from TileHolder's adhesive surface for optimal bond strength. If the protective liner remains in place, the adhesive stays protected from dust, dirt, and debris, allowing flexible installation scheduling up to 48 hours. Important: Once tiles are placed on TileHolder, complete grouting within 24 hours of tile installation for best results.

Yes, TileHolder allows for repositioning during installation. Once tiles are placed, they can be adjusted before pressure is applied. Once pressure is applied, the tiles will be very difficult to reposition. The TileHolder has an aggressive adhesive on both sides.

Each Standard Roll provides 15 square feet of coverage (12 inches wide × 15 feet long = 15 sq ft). The roll includes approximately 4 inches of material that remains on the core for handling, which is factored into our coverage calculations.

Yes, TileHolder is suitable for kitchen backsplash applications behind stoves and cooktops. The adhesive withstands normal cooking temperatures. However, maintain standard clearances from heat sources as required by local building codes.

TileHolder is engineered specifically for vertical wall applications. Floor installations require different adhesive properties to handle foot traffic, structural loads, and potential moisture exposure that exceed TileHolder's design parameters.

While TileHolder creates a permanent bond, it's excellent for rental properties because it eliminates the mess and complexity of traditional mortar mixing. However, removal may require tile replacement, so consider this for temporary applications.

TileHolder supports tiles up to 8" × 8" and maximum 3.5 lbs per square foot. This covers most standard ceramic, porcelain, and glass mosaic tiles used in backsplash and accent wall applications.

Yes, TileHolder is waterproof and suitable for shower walls when properly sealed with TileHolder Waterproofing Seam Tape at all joints. Not recommended for shower floors or areas with direct water impact like shower heads.

TileHolder supports tiles up to 8" × 8" and maximum 3.5 lbs per square foot. This covers most standard ceramic, porcelain, and glass mosaic tiles used in backsplash and accent wall applications.